Changing the seven series graphics card can't get into the system (changing the graphics card can't get into the system)

After the 10th generation CPU installed win7, it needs to press Enter to enter the system.

Unable to install gasket for vga BIOS: Press Enter for unsupported hardware to continue.

Note: the hard disk partition must be WIN7 installed in globally unique identifier.

When physical education class chooses physical education class with USB3.0 injection to install the system, check Injection.

Otherwise, the mouse and keyboard may not work after entering the desktop.

ASUS motherboard H410M is installed with win7 system, and the following interface appears after restarting or booting. You need to press Enter to enter the system.

This is very distressing.

As shown in the following figure

【 Operation Steps 】 First, we restart and press the delete key on the keyboard to enter the interface of the basic input and output system of ASUS motherboard.

Press F7 on the keyboard to enter advanced mode and then go to option boots.

Then find the command and service module in the figure. After we select it, press Enter to enter this option.

Select start CSM carriage return to change the defective to enable the option at the beginning.

Finally, press F10 to rescue and save.

After saving, you will exit the basic input and output system and restart the computer.

If you restart or boot now, there will be no beginning. In that case, you need to press Enter to enter the system.

I hope it helps you.

My configuration here is I5 10400F+ASUS H410M+1030 graphics card.